Monday - Friday 8AM - 5PM
Saturday 8AM - 1AM
Saturday 8AM - 1AM
Al Barsha 1 - Dubai
Sajaa Sharjah
Sajaa Sharjah
Innovative QUICK LOAD® liners install from the front of the MIG gun in less than half the time required to install conventional liners, increasing uptime, cost savings and safety.
Requires less than half the time and effort to replace (compared to conventional liners)
Two-piece system with retainer installed inside the power pin on first use
Liner portion feeds from the front of the MIG gun
No need to cut and waste wire!
Avoid climbing over robotic tooling or transfer systems to remove the torch from the wire feeder
Change the liner from a safe zone in the robotic work cell
No need to climb up to change liners in semi-automatic MIG guns connected to boom mounted feeders
| Part Number | Description |
|---|---|
| 415-35-6Q | for 0.035″ – 0.045″ wire, 6′ length; high carbon steel – round wound |
| 415-35-10Q | for 0.035″ – 0.045″ wire, 10′ length; high carbon steel – round wound |
| 415-35-15Q | for 0.035″ – 0.045″ wire, 15′ length; high carbon steel – round wound |
| 415-35-25Q | for 0.035″ – 0.045″ wire, 25′ length; high carbon steel – round wound |
| 415-116-6Q | for 0.045″ – 1/16″ wire, 6′ length; high carbon steel – round wound |
| 415-116-10Q | for 0.045″ – 1/16″ wire, 10′ length; high carbon steel – round wound |
| 415-116-15Q | for 0.045″ – 1/16″ wire, 15′ length; high carbon steel – round wound |
| 415-116-25Q | for 0.045″ – 1/16″ wire, 25′ length; high carbon steel – round wound |
Required for initial installation only (sold separately)
| Part Number | Description |
|---|---|
| 415-26* | for 0.030″ – 5/64″ wire |
| 415-37** | for 0.030″ – 5/64″ wire |
*Compatible with Tregaskiss® TOUGH GUN® robotic and fixed automatic MIG guns and Bernard® BTB and TGX® semi-automatic air-cooled MIG guns
** Compatible with most Tweco® MIG guns
